Dotpanel installation
IMPORTANT SAFETY INSTRUCTIONS
This component is for indoor use due to its IP44 protection (to achieve better sealing you must close it in a space that guarantees the required IP). IP-65 option is possible on request. Regularly check the cable, transformer and all other components for damage. If any component is damaged, the product should not be used.
Important information! Keep these instructions for future reference.
WARNING!
The light source of this product consists of light-emitting diodes (LEDs) that cannot be replaced. Do not disassemble the product; the LEDs may cause eye damage. Do not immerse in water.
Output connectors to power supply
Easy Connector
Jack
Stripped cable
Dimming
Connection to Dotpanel dimmer:
*Do not connect to 230V. Dotpanel is a low voltage product.
Manipulation
Transportation
Panels, especially large ones, must be handled and transported vertically to avoid buckling problems.
Remove the protector
Remove the protective plastic before using Dotpanel.
Do not vinyl directly, use opal on the panel.
DO NOT vinyl directly on the panel, Dotpanel is a light source.
Alternatively, you can vinyl an opal and place it on top.
Drilling, cutting or punching
Joining of several panels
Further manipulation of the panel is NOT recommended. Tampering without implied consent will void the warranty. If necessary, drilling can be done by us according to the indications for a correct final result.
In the event that the decision is made to drill a hole, the following guidelines should be followed, exempting Actilum from any responsibility. Do not drill in the profile area under any circumstances. Use a drill with a 3-point drill bit on the rest of the surface.
If you need to illuminate an area larger than the maximum allowed manufacturing area, you can join (place one next to the other) several Dotpanels to cover larger dimensions, as long as you take into account the separation between the graphic and the Dotpanels.